peerless-AV SA771PU Manual De Instrucciones página 11

For Flat Back Display
3-4
Begin with the shortest length screw, hand thread
screw through multi-washer and display brackets
(B) into display as shown below. Screw must make
at least three full turns into the mounting hole and
fi t snug into place. Do not over tighten. If screw
cannot make three full turns into the display, select
a longer length screw from the baffl ed fastener
pack. Repeat for remaining mounting holes, level
display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon
the type of display.
Skip to step 3-6.
For Bump-out or Recessed Back Display
3-5
Begin with the longest length screw, hand thread
screw through multi-washer, display brackets (B)
and spacer in that order into display as shown
below. Screw must make at least three full turns
into the mounting hole and fi t snug into place.
Do not over tighten. If screw cannot make three
full turns into the display, select a shorter length
screw from the baffl ed fastener pack. Repeat for
remaining mounting holes, level display brackets
and tighten screws.
3-6
Center display brackets horizontally and vertically
on back of display. Tighten two 1/4-20 x 1.25"
screws. Reinstall four 1/4-20 x .6" screws using
5 mm allen wrench (I) into appropriate fi xed-stop
position from chart on page 9.
DISPLAY
B
DISPLAY
B
1/4-20 x 1.25" SCREWS
11 of 70
ISSUED: 10-30-09 SHEET #: 095-9299-11 03-22-12
MULTI-WASHER
MULTI-WASHER
SPACER
1/4-20 x .6" SCREWS
SCREW
SCREW