Offset Position Adjustment - Oki LD610 Guía De Instalación De Accesorios

offseT PosiTion adjusTmenT

This setting adjusts the option (Tear off, Cutter, Dispenser) stop position after a print out.
By sending command to the printer, the stop position can be adjusted within the range of ±99 dots.
1. Prepare the printer to be ready for print out.
Ensure the required media are loaded and the printer is in Online mode.
2. Send the appropriate command to adjust the tear off, cut or dispense position accordingly as follows.
Commands:
• Tear off position offset command is <PC>21,b
• Cut position offset command is <PC>22,b
• Dispense position offset command is <PC>23,b
b: vertical offset position in dots (-99 to +99)
A positive value moves the offset position of the label forward (away from the print head) while negative value
moves the offset position of the label back to the mechanism.
example: To set the Cut position offset with the cutting edge of the label move forward 8 dots.
<A>
<PC>22,+8
<Z>
3. Print a User Test print to check the offset position.
Send the test print command (<TP>,2) to execute User test.
4. If the print start position does not meet the criteria, repeat from step 2 above.
Adjustment of
Offset setting
Stop position for
cutting,dispense
or tear-off
Label feed direction
+ Adjustment
zero
Adjustment
- Adjustment
+99 dots
Reference position
for printing
-99 dots
11