Oki LD610 Guía De Instalación De Accesorios página 9

Ocultar thumbs Ver también para LD610:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

disPenseR insTallaTion (ConTinued)
3. P eel off the first two leading labels from the liner (backing
paper) and then load the label roll on the media holder.
after pulling out the leading liner (backing paper), pass
the liner (backing paper) through the media guides
and then pass over the dispenser bar so as to cover it.
Then pass the liner (backing paper) behind the pressure
bracket as shown and out of the front of the printer from
below the pressure bracket (3).
4. If the paper is not taut, roll the paper on the media holder so
that the paper is taut.
Next, tightly close the pressure bracket with the liner
(backing paper) passing through it.
5. Close the top cover until it clicks into position.
6. After turning on the label, turn on the power.
The printer is online and the on line (PoWeR) indicator
lights green.
When the printer is ready, press the feed/line button
to output an empty label and stop at the dispenser. This
procedure is to ensure that the label is loaded correctly.
Media guides
Dispenser bar
Label output
from here
Output
backing
paper
9

Publicidad

Tabla de contenido
loading

Tabla de contenido