Overhead Rigging - JB Systems PARTY BEAMS Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

ENGLISH

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper

installation can result in serious injuries and/or damage to property. Overhead rigging requires

extensive experience! Working load limits should be respected, certified installation materials

should be used, the installed device should be inspected regularly for safety.

 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.

 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The

fixture must be fixed at least 50cm from surrounding walls.

 The device should be installed out of reach of people and outside areas where persons may walk by or be

seated.

 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's

weight.

 Always use a certified safety cable that can hold 12 times the weight of the device when installing the unit.

This secondary safety attachment should be installed in a way that no part of the installation can drop

more than 20cm if the main attachment fails.

 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!

 Don't cover any ventilation openings as this may result in overheating.

 The operator has to make sure that the safety-relating and machine-technical installations are approved by

an expert before using them for the first time. The installations should be inspected every year by a skilled

person to be sure that safety is still optimal.

HOW TO SET UP AND CONTROL THE UNIT

You can operate the unit in several ways:

1) FULL AUTOMATIC STANDALONE MODE:

The effect automatically runs a preprogrammed sequence. Select this mode when only 1 PARTY BEAMS

unit is used (standalone) or when the unit is placed as the first (master) unit in a chain with several PARTY

BEAMS.

 Press the [MENU] button until the display shows [Aut].

 Press the [ENTER] button to confirm your choice.

 Now you can use the UP or DOWN buttons to select the desired effect group:

[AutP] Automatic RGB projector show.



[AutF] Automatic white flash show.



[AutM] Automatic mixed effects show.



JB SYSTEMS®

Press [ENTER] to select this mode.

Use the [UP] and [DOWN] buttons to select one of the 23 shows [AP01 – AP23]