Connecting Your Clearone; To A Standard Telephone Line - Gentner ClearOne Guía De Usuario

Figure 2
Connecting
Your ClearOne
Installing your ClearOne is as easy as
installing an ordinary telephone. You
can connect your ClearOne to the
following:
• A standard telephone line
• A PC with a sound card, or other
four-wire system
• A modem and computer
• Two-line telephone service
• A digital telephone system
• An audio recording device
4
Figure 3
Connecting to a Standard
Telephone Line
Before connecting your ClearOne,
verify that you have standard analog
phone service. If you have digital (PBX)
telephone service, you need a digital-to-
analog telephone line converter. For
more information, contact Gentner
technical support.
To connect your ClearOne to a
standard telephone line:
1. Set the ClearOne base unit on a table
or desk in the middle of your
conference area.
2. ClearOne is preset for Touch-Tone
dialing. If your local telephone service
does not support Touch-Tone
dialing, slide the PULSE/TONE
switch (found on the bottom of the
base unit) to the PULSE position.
3. Plug the RJ11 (4 pin) telephone cord
from the power supply into a standard
telephone wall jack.
4. Plug the base connector cable from
the power supply into the RJ45 (8 pin)
jack on the ClearOne base unit.
5. Plug the power cord into a standard
120-volt electrical outlet. If the outlet is
controlled by a wall switch, turn it on.
The ClearOne plays a sequence of self-
test tones.
6. Press the ON/OFF button to check
for a dial tone. If a dial tone is present
the unit is ready for operation. If you
don't hear a dial tone, see
"Troubleshooting" in this manual.
5