Tank Installation Instructions - Dyna-Glo HA1360RH Manual De Usuario E Instrucciones De Funcionamiento

TANK INSTALLATION INSTRUCTIONS

Tank Installation for DOT Certified 1 lb. Propane Cylinder(s) (Fig. 1)
• Open easy access tank compartment door(s).
• Locate regulator and swivel it upward by hand to provide better access for cylinder
• Attach cylinder(s) to swivel mount by gently turning clockwise until it is hand tight. Do not overtighten. Do not use tools to tighten.
• Check for gas leaks by using a 50% soap-water solution at the joint of the regulator and cylinder.
Tank Installation for 20 lb. Propane Cylinder (Fig. 1a)
• Open easy access tank compartment door(s).
• Locate regulator and swivel it upward by hand to provide better access for hose end adapter.
• Attach Fuel Filter, Model HAKITDG to swivel mount by gently turning clockwise until it is hand tight. Do not over tighten. Do not use tools
to tighten.
• Attach GHP hose end adapter (No. HAKITDG ) to fuel filter by gently turning clockwise until it is hand tight. Do not overtighten.
Do not use tools to tighten.
• Check for gas leaks by using a 50% soap-water solution at the joint of the regulator and hose end adapter.
Fig. 1 - 1 lb. Cylinder Tank Installation
Fig. 1 - 1 lb. Cylinder Tank Installation
EMERGENCY INDOOR USE
• Adequate combustion and ventilation air must be provided when the appliance is in use. Refer to General Safety Instructions on
Page 4 for additional information.
• Only disposable 1 lb. cylinders, marked as PROPANE can be used with this heater.
• NEVER bring a refillable propane cylinder indoors. A fire or explosion can occur causing property damage, serious injury, or death.
Regulator
Access Door
1 lb. DOT Approved
Cylinder Tank
Regulator
Fig. 1a - Remote Tank Installation
5
Figure 1a - Remote Tank Installation
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
Recommended Fuel Filter
Model HAKITDG
Access Door
20 lb. Tank Hose
Model HAKITDG