Function Description; Intended Use; Initial Operation; Scope Of Delivery - FLORABEST FSG 85 B1 Traducción Del Manual De Instrucciones Original

Function description

Prior to first starting the appliance, firmly
mount it on a worktop. It is driven by an
electric motor with protection against
overheating and restart for added safety.
The rake angle is easily adjustable be-
tween -30° and +30° using a rotary disk.
The chain guide rail has a variably ad-
justable stopper. To sharpen, swivel the
grinding head. The equipment is fitted with
a protective screen in order to protect the
user.
For the function of the operating parts,
please refer to the descriptions below.

Intended use

The chain sharpener is suitable for sharpen-
ing the standard saw chain types.
The equipment is not designed for any
other type of application (e.g. grinding with a
coolant liquid, grinding other work pieces or
materials such as asbestos, which are haz-
ardous to health).
The equipment is intended for use in the
field of DIY. It is not designed for commercial
use.
The equipment is designed for use by
adults. Young people under the age of 16
are permitted to use the equipment only un-
der supervision.
The manufacturer shall not be liable for
damages caused by use other than for the
intended purpose or by incorrect operation.

Initial operation

Scope of delivery

Unpack the equipment and check that it is
complete:
• Chain sharpener with grinding disk
installed
• Handle
• Chain clamping unit and locking screw
• Adjusting screw and nut
• Two screws, nuts and washers for
mounting on the worktop
Dispose of the packaging material correctly.

Installation

Always use the M10x70 screws
from the package to mount the
unit.
Make sure to leave enough room
for working and that nobody
else is put at risk.
Always use screws of sufficient
length and thickness to mount
the device on the work surface,
in order to prevent loss of con-
trol of the device.
Installing the appliance:
• Thickness of the table edge:
15 - 30 mm.
• Drill diameter: 10.5 mm.
• Size of screw: M10
1. Use the stop notches (9) to cor-
rectly place the appliance on the
worktop (22). Make sure that the
grinding plinth (8) protrudes be-
yond the edge of the table.
2. Use a pen to mark the drill holes
and remove the appliance.
3. Drill two holes into the worktop
(22).
4. Use the screws (23) and nuts
GB MT
45