Auxiliary Device (Optional); Operating Auxiliary Devices (Optional) - Alpine IVA-D100 Manual De Instrucciones

Auxiliary Device
(Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear
panel of IVA-D100, follow the procedure described below.
WARNING
It is dangerous (and illegal in many states) for the driver to
watch the TV/Video while driving the vehicle. The driver may
be distracted from looking ahead and an accident could
occur.
Install the IVA-D100 correctly so that the driver cannot watch
TV/Video unless the vehicle is stopped and the emergency
brake is applied.
If the IVA-D100 is not installed correctly, the driver will be
able to watch the TV/Video while driving the vehicle and may
be distracted from looking ahead and cause an accident.
The driver or other people could be severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the AUX mode operation has been
released. Engaging the parking brake can reactivate the AUX
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
"To activate your auxiliary devices."
Each time the ignition is turned OFF, perform the procedure of "To
activate your auxiliary devices."
• If you try to activate the auxiliary device while driving, the
display will show the warning-PICTURE OFF FOR YOUR
SAFETY.
1
Press SOURCE/POWER.
The source screen appears on the display.
2
Touch [ ] of AUX*.
The external input screen is displayed.
* The name which is given as the source name in "Setting the AUX
Mode" on page 35 is displayed.
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following "Setting the AUX Mode" (page 35).
• The display mode changes by touching [WIDE].
For operation, refer to "Switching Display Modes" on page 26.
48
-EN
• When the KCA-410C is connected, the AUX input of the KCA-410C
can be used only in INTERRUPT MODE. For details, refer to the
KCA-410C Owner's Manual.