Descargar Imprimir esta página

Hayward AquaVac 500 Serie El Manual Del Propietario página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

To better protect the cleaner from damage, it will sense when being asked to turn on when not safely in
water, or leaves the water during operation.
Out of Water Start Up
Out of water at start up means that the cleaner has been powered on before the cleaner has been placed
in the water. If the cleaner senses that it is not in the water the unit will power itself down. To reset the
cycle, switch off the power supply for 10 seconds and restart.
Out of Water Operation
Out of water during operation refers to the cleaner leaving or being removed from the water while in normal
operation cycle. If the cleaner senses that it is no longer in the water, the unit will attempt to
re-enter the water by reversing its current direction. If the cleaner is not submerged within ninety (90) seconds
of leaving the water the unit will power itself down. To reset the cycle, switch off the power supply for 10
seconds and restart.
CAUTION: When removing cleaner from the pool do NOT reel it around your arm. The cleaner is heavy
and may cause someone to lose their balance and fall into the pool. To avoid falling into the pool, gently
reel the cable in hand-over-hand from the shallow end of the pool by gently pulling the cable until the
cleaner reaches the surface. Then lift it out of the water using the handle, NOT the cable.
DO NOT ENTER THE SWIMMING POOL WHEN THE CLEANER IS OPERATING OR IN THE POOL.
Optimum operating water temperature range for the cleaner is 50ºF - 100ºF (10ºC - 35ºC).
Remove the cleaner from the pool, empty the filter bucket and clean filters after each use. Keeping the
cleaner permanently in the pool may result in additional service requirements. (see maintenance section for
cleaning instructions)
Keep the Power Supply Control Out of Direct Sunlight. Store the Cleaner and Power Supply in a
shaded area.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Out of Water Sensor
op
11

Publicidad

loading