Pre-Installation - K2 Pumps UTM01602K Manual De Instrucciones

20. Before using the pump, check the hose for holes or excess wear, which could cause leaks, and ensure the hose is
not kinked or making sharp angles. A straight hose allows the pump to move the greatest amount of water quickly,
and also check that all hose connections are tight to minimize leaks.
21. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.

PRE-INSTALLATION

APPLICATION
This submersible utility pump is designed for water removal applications. Pump water only with this pump. It can

drain or remove water from the following: pits, sinks, window wells, basements, swimming pool covers, boats, low
spot in yards, or other flooded areas.
This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. This pump is

not designed to function as a permanently installed sump pump. It is also not engineered to be run continuously as
a "fountain" or "waterfall" pump.
Do not use where water recirculates.

Not designed for use as a swimming pool drainer.

Function:
Operating water depth: minimum 1 in.
TOOLS REQUIRED
Flathead
Screwdriver
MATERIALS REQUIRED (NOT INCLUDED)
NOTE:
The hose and hose kit are not shown to scale.
SPECIFICATIONS
Power supply
Liquid Temp. Range
Discharge
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Garden
Hose
115V, 60 HZ., 10 Amp Circuitminimum
32 to 95° F (0- 35° C)
1 in. Male NPT or 3/4 in. garden hose thread
Wrench
Safety
Goggles
Sump
Pump
Discharge
Hose Kit
3