Pre-Installation - K2 Pumps SPI03302K Manual Del Usuario

17. Follow all local electrical and safety codes, along with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA) guidelines must be followed.
18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will reset
itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.

PRE-INSTALLATION

APPLICATION
This submersible sump pump is designed for home sump applications. Use this pump only for pumping water.

 This unit is not designed as a waterfall or fountain pump, or for applications involving salt water or brine! Use
with waterfalls, fountains, salt water or brine will void warranty.
Do not use where water recirculates.

 Not designed for use as a swimming pool drainer.
TOOLS REQUIRED
Flathead
Screwdriver
Hacksaw
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Safety goggles
Cable Ties
Channel
Locks
Tape Measure
Pipe wrench
3