Novik Neo ROLLING SOUND 15BT Manual De Instrucciones página 12

WIRING:
1) RCA Connector
This kind of connector is used for audio
input and output signal line, such as mixers,
laptops, CD players and tape. Each connector
transmits a mono signal, but is usually used
in pairs to transmit stereo signals.
3) Mono Plug Connector 6.3mm (1/4¨)
Tip (tip) = Signal
Sleeve (sleeve) = ground / shield
Strain relief clamp
Sleeve
Tip
Unbalanced " TS connector
TROUBLESHOOTING
The device does not turn on
Thereis no sound
The sound is weak, distorted or noisy
Sleeve Pin
Sleeve
Tip
(ground/shield) hot (+ve)
• Is the device connected to an appropriate alter current net
through the voltage wire provided by the manufacturer?
• Is the switch on?
• Are the wires correctly connected?
• Is the audio signal received in the loudspeaker?
• Is the level control correctly adjusted?
• Has the input signal the correct level to enter in the device?
• Are the wires damaged?
• Move the wires and keep them far from noise sources.
• Move the monitors and the wires of any device that can
produce interferences (cell phones, transformers, etc.)
2) Balanced XLR Connectors
Input
1 = Ground / Shield
2 = Hot (+ve)
3 = Cold (-ve)
For unbalanced use, pin 1 and pin 3 have
to be bridged
4) Balanced ¼" TRS Connector
Strain relief clamp
(ground/shield)
Sleeve
Ring
Tip
www.novikneo.com
Output
Tip
hot (+ve)
Sleeve
Ring
cold (-ve)
12