1
MIC VOL: Use this knob to regulate the microphone output volume
2
ECHO: Use this knob to adjust the echo effect.
3
MP3 VOL: Use this knob to adjust the volume of MP3 Player
TREBLE: This knob is used to adjust amount of high frequency signal, the maximum
4
amount of high frequency signal gain is +15 dB and the maximum amount of high
frequency signal decrease is -15 dB
5
BASS: This knob is used to adjust amount of low frequency signal, the maximum
amount of low frequency signal gain is +15 dB and the maximum amount of low fre-
quency signal decrease is -15 dB
6
MASTER VOL: Use this knob to adjust the general signal amount of the loudspeaker
MIC IN (XLR & 1/4" plug): Use these connections for microphone input.
7
8
LINE IN (RCA & XLR): This XRL connection is designed to accept a balanced line input
signal from a mixer or other line level device with a balanced output jack. Use a balanced
cable, when the signal cable length exceeds 5 feet, it will reduce excessive signal loss.
Be sure to connect only line level input devices such as mixers and tape machines to
this jack. For unbalanced signals use the RCA input connector.
LINE OUT (XLR &1/4" Plug): This connection is used to send the incoming line level
9
and mic signal from either of the line level inputs jacks to another active speaker box or
other line input jack such as a mixer or power amp.
3
rf a
1
min max
ant a
ANT A : Antenna of Channel A
1
ANT B : Antenna of Channel B
2
RF A Indicator: If the led shines, Channel A VHF microphone is working
3
RF B Indicator: If the led shines, Channel B VHF microphone is working
4
VOL A: Use this knob to adjust the amount of Channel A VHF microphone
5
6
VOL B: Use this knob to adjust the amount of Channel B VHF microphone
7
VHF POWER Indicator: When VHF wireless microphone is on, it will shine
8
ON/OFF SWITCH: Down to switch on the VHF microphone, up to switch off
the VHF microphone
4
5
6
rf b
min max
vol av
ol b
7
wireless
mic power
2
8
on
ant b
off
www.novikneo.com
8