ScorpionExo EXO-TECH Manual De Instrucciones página 4

KwikWick ® III
EN
Liner Removal
CHEEK PADS REMOVAL
Occassionally the interior may require removal for washing
or replacement.
1. Slide your thumb behind the cheek pad.
2. Gently tug the cheek pad away from the helmet interior
wall. There are three plastic snaps that require unsnapping.
At the same time slide the plastic trim out of the helmet
channel.
Repeat this process for both cheek pads.
Reverse this process for installation.
5
CROWN LINER REMOVAL
1. Remove the cheek pads.
2. At the back of the helmet pull the crown liner away from
the shell unsnapping the two snaps.
3. Pull the crown liner out of the helmet while gently
detaching it from the forehead channel.
Reverse this process for installation.
Note: The aero skirt is not removable. Flip the chin bar back
before removing the cheek pads or the crown liner.
Opening the
Flip-back Chin Bar
A
B
A
B
EN
While holding the upper part of chin bar (A)
with one finger, push the lever up (B) and away
the chin bar from face.
Rotate the chin bar until it is fully tucked in the back of
the helmet. Be sure to hear the "click" sound.
The shield will be automatically opened while rotating
the chin bar. You can lower the shield while the chin bar
is tucked in the back.
6