Safety Instructions - IKA WERKE RW20 digital Indicaciones De Seguridad

Contents
CE - Declaration of conformity
Safety instructions
Correct use
Unpacking
Motor protection
Gear speed change
Speed display
Commissioning
Attaching - stirrer
- stirrer tools
- stirrer shaft protection device
Switching on the device
Output shaft
Maintenance
Warranty
Accessories
Permitted IKA stirrer tools
Technical data

Safety instructions

• Read the operating instructions in full before starting up
and follow the safety instructions.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• The voltage stated on the nameplate must correspond to the
mains voltage.
10
• Socket must be earthed (protective ground contact).
• Wear your personal protective equipment in accordance with the
hazard category of the medium to be processed. Otherwise
Page
here is a risk of:
2
- splashing liquids
10
- projectile parts
11
- body parts, hair, clothing and jewellery getting caught.
11
• Set up the appliance in a spacious area on an even, stable, clean,
11
non-slip, dry and fireproof surface.
12
• The feet of the appliance must be clean and undamaged.
12
• Position the knob (B) at the left stop before starting up. Gradually
12
increase the speed.
12
• Reduce the speed if
- the medium splashes out of the vessel because the speed is
too high
13
- the appliance is not running smoothly
13
- the appliance begins to move around because of dynamic forces.
13
• Firmly secure the accessories and vessels in place, otherwise
14
shaking vessels could be damaged or projected out.
14
• Check the appliance and accessories beforehand for damage
14
each time you use them. Do not use damaged components.
15
• The equipment is not suitable for manual operation.
• Beware of the risk of
- flammable materials
- glass braekage as a result of mechanical shaking power
• There may be dangerous electrostatic activity between the
medium and the output shaft
• Only process media that will not react dangerously to the
extra energy produced through processing. This also applies
to any extra energie produced in other ways, e.g. through ligh
irradiation.
• Do not operate the appliance in explosive atmospheres,
with hazardous substances or under water.
• Safe operation is only guaranteed with the accessories desci
bed in the "Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• The appliance starts up again automatcally following a cut in
the power supply.
EN
RW20d0506