Daintree GE current LIS Serie Guia De Instalacion página 7

Lumination LIS Series
®
Wiring Diagrams
Wiring Diagrams
Wiring Diagrams
DALI 0-10V
DALI 0-10V
DALI 0-10V
Fixture
Fixture
Fixture Fixture
Fixture
Fixture
Black
Line Black
Line
Black Line
Line
White White
Neutral Neutral
Neutral Neutral
White
Neutral Neutral
Ground Green
Ground Green Ground
Ground
Ground Green
Ground
DALI Violet/White
DALI Violet/White
(0-10V)+
(0-10V)+
DALI Violet/White
(0-10V)+
DALI Violet
DALI Violet
(0-10V)–
(0-10V)–
DALI Violet
(0-10V)–
3
Pull out con�nuous wiring
Pull out con�nuous wiring Pull out con�nuous wiring
6
Pull the continuous wiring out of the luminaire being mounted and slide the bridge of the luminaire down onto the bridge of the
already installed luminaire so that the tabs and slots at top and bottom nest into one another. The bridges will engage with a loud click
when fully mated.
7
Connect the power and control
connectors of the through wiring
harness.
Previously
Previously
Previously
hung unit
hung unit
hung unit
Black
Line Black
Line
Black
White White
White
Green
Green
Green
Violet
Violet
Violet
Grey
Grey
Grey
4
To add a continuous unit to a
continuous run, first suspend the
new unit as it is done in steps 9 and
10 for the independent unit. Position
the non-power-supply end of the
luminaire near the power-supply end
of the previously hung luminaire.
Align tabs
Align tabs Align tabs
withslots
withslots withslots
8
At the beginning of the row, push
the wiring inside the cavity of the
bridge.
10
Replace the PSU cover(s) and
secure using the mounting screws.
Note: When installation is complete, all
lead wires and connectors shall be totally
enclosed.
Newunit
Newunit
Newunit
7
Installation Guide
5
Remove the PSU cover from the
previously hung luminaire if
present.
Push down
Push down Push down
to engage
to engage to engage
9
Clip one end-cap at the beginning
of the row and one at the end
(provided in the starter kits).