Your Cls45I; Installing, Replacing And Charging The Handset Battery Pack - Plantronics Clarity CLS-45i Instrucciones De Operación

Installing and Using Your CLS45i
There are six (6) steps involved in setting up

your CLS45i.

1. Install included battery pack into handset.
2. (Optional) Insert four AA alkaline batteries
(for backup in case of AC power outage)
into base.
3. Decide if you want the telephone to sit
on a desk/tabletop or hang on the wall (if
on the wall, follow Instructions for Wall
Mounting)
4. Plug the telephone line cord into the phone
base and telephone wall jack
5. Plug the electrical adapter into a 110-120V
AC wall outlet
6. Place handset in the cradle face up and let
charge overnight or for 10-14 hours
Once your telephone is set up and the
handset is charged, you may proceed to
program up to 17 phone numbers into the
memory speed-dial buttons and set up the
rest of the Special Features.
Installing, Replacing and
Charging the Handset
Battery Pack
Note: the battery pack must be fully charged
before using the CLS-45i
Remove the battery cover on the back of the
handset by pushing the battery compartment
"button" and sliding the cover towards the
bottom of the handset.
1.To install the battery pack, plug the
cord of the battery pack into the terminal
in the battery compartment. Replace the
battery cover by sliding it into place until it
"clicks".
2.To replace the battery pack, remove the
battery cover as stated above and unplug
the battery from the battery compartment.
Remove old battery pack. Install new battery
pack and plug the cord of the battery pack
into the terminal in the battery compartment.
Replace the battery cover by sliding it into
place until it "clicks".
Monitoring the Handset
Battery Level
The battery icon will show "full" if there is
an adequate charge level on the battery. As
the phone is used the battery will discharge.
When the handset battery is low the display
will show the battery icon in an "empty"
state, the unit will "beep" every thirty (30)
seconds, and the IN USE/NEW CALL light will
flash. If you are using the phone, the phone
will go dead after approximately two (2) min-
utes. Place the handset back into the base to
recharge the battery.
11