Erreka KAIROS Guía Rápida De Instalación Y Programación página 21

LED Display Definition
FC Photocell1
FD Photocell2
FE Buzzer function
FF Latch release function
FG
Open/Stop/Close/Stop
function key
FH Pedestrian Mode function
key
FI Auto-Close function key
Note (Parameter F3)
Please set F3 function after system learning. The LED display 10 to indicate all of the recorded values will increase 1 ampere as
the over current value. In other words, the LED shows 20 to indicate all the recorded values will increase 2 ampere as the over
current value. The value can be adjusted by pressing button UP and DOWN. The maximum value is 40(4.0A) and the minimum
value is 05 (0.5A)
Function Settings
Parameter Mode
FC-0 OFF
FC-1 ON
FD-0 OFF
FD-1 ON
FE-0 OFF
FE-1 ON
FF-0 OFF
FF-1 ON
FG-1 A key
FG-2 B key
FG-3 C key
FG-4 D key
FH-0 OFF
FH-1 A key
FH-2 B key
FH-3 C key
FH-4 D key
FI-0 OFF
FI-1 A key
FI-2 B key
FI-3 C key
FI-4 D key
Description
1. The factory setting is "FC-0".
1. The factory setting is "FD-0".
1. The factory setting is "FE-1".
1. if the function is on, the gate will move forward a little
before the gate operate for releasing the Latch
2. The factory setting is "FF-1".
1. The factory setting is "FG-1".
1. The factory setting is "FH-2".
1. The key is to turn on or off the Auto-Close function.
2. The factory setting is "FI-3".
3. When the flasher and buzzer is running, the auto
closed button has no function till flasher and buzzer
finish running.
9