Publicidad
1
1
Note: In some cases you may need to close the mount
between your bindings. Position them fore/ aft to best
avoid hatch contact. You can also flip the mountin
clamps so the knobs clear your bindings.
If your bindings contact the vehicle use
the SkiLift accesory #8860037 (sold
separately). Follow the instructions that
came with your SkiLift accessory to install.
1.
Unlock the mounts.
2. Press the button to open the mounts.
3. Carefully remove your fishing rods, skis, or boards.
4. Close and lock the mounts.
Rack
Porte-bagage
Portaequipaje
Check the Yakima Fit List, or go to yakimatech.com for your roof's weight limit.
Instrction #1035942B - Page 3 of 7
*
ReelDeal
ReelDeal
6 lbs (2.7 kg)
Press the buttons and open the mounts.
Load your rods with tips toward the front of the vehicle
(break down rods if over 7'). TIP: Use rubber bands to
secure the ends.
Position the reels between the carriers for added security.
mounted in either direction.
Avoid placing rod eyeholes against the mounts.
Avoid pinching by placing rods 1" away from the pad ends.
accessory #8860037 (sold separately).
Verify closure by pulling upward on the rods to see if the
mount opens. If they open, apply more pressure when
closing the mounts.
Use the keys to lock your mounts.
Press the buttons and open the mounts.
Load your skis keeping the tips toward the rear
of the vehicle.
Load bindings between the mounts.
Close mounts with firm pressure.
For additional roof to binding clearance use the
Verify closure by pulling upward on the skis to
see if the mount opens. If they open, apply more
pressure when closing the mounts.
Use the keys to lock your mounts.
g
1.
Loosen the security screws (do not remove them).
2. Loosen the knobs enough to rotate the t-bolt,
and open the clamps.
3. Carefully lift the mounts from your vehicle.
*
Load
=
Charge
Carga
Not more than 165 lbs. (75 kg)
unless otherwise noted.
Publicidad
