X-LITE X-1005 Seguridad E Instrucciones página 21

REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- side cheek pads (right and left)
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
Deactivate the VPS and lift the helmet chin guard to remove and/or install the comfort
padding (see instructions above).
1 DISASSEMBLING THE CHEEK PADS
1.1 Open the chin strap (see specific instructions) and remove the chin strap band
from the elastic loop on the cheek pad strap (Fig.13).
1.2 Pull the front of the left cheek pad towards the inside of the helmet to release the
three buttons on its back (Fig. 14)
1.3 Remove the rear flap of the comfort padding of the left cheek pad from the cavity
between the rear trim and the polystyrene inner shell. Then completely remove the
cheek padding from the helmet (Fig.15).
1.4 Repeat these steps with the padding of the right cheek pad.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To facilitate the washing of the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after disassembling the cheek
pads from the helmet (see instructions above).
2.1 Unhook the three eyelets "A" of the rear frame of the left cheek pad slot next to the
two snap buttons (front and rear) on the back (Fig.16).
2.2 Carefully remove the inner expanding foam padding from the fabric lining of the
left cheek pad (Fig.17).
2.3 Repeat these steps with the padding of the right cheek pad.
Warning: once the inner paddings made of expanding foam have been removed
from the cheek pads, ensure that rear "B", front "A" and rear "A" snap buttons are
correctly hooked to the rear frame of the fabric lining of the cheek pads (Fig.18).
Otherwise, position them again appropriately.
3 DISASSEMBLING THE LINER
3.1 Pull the front part of the comfort padding towards the inside of the helmet, at the
relevant central puller, to release the left and right rear tabs on the liner from the
rear edge of the shell (Fig. 19).
3.2 Remove the adjustment flap from the rear cavity between the outer shell and the
polystyrene inner shell.
INSTRUCTIONS FOR USE
X-1005
21