X-LITE X-1005 Seguridad E Instrucciones página 23

6.4 Repeat these steps with the padding of the right cheek pad.
Warning: the buttons are not fastened until a click is heard. Check that the strap
comes out properly from the cheek pad padding.
6.5 Insert the chin strap band into the elastic loop on the cheek pad strap (Fig. 13).
WARNING
- If your helmet is equipped with the D-Ring retention system, pull it down as
indicated in the attached D-Ring label.
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely fitted.
- Carefully wash by hand and use only neutral soap and water at 30° max.
- Rinse using cold water and dry at room temperature, away from direct sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the internal polystyrene components in any way.
- Clean the inner polystyrene components using a damp cloth only and allow it to
dry at room temperature away from direct sunlight.
- Never use tools or equipment of to carry out the steps described above.
LINER POSITIONING CONTROL (LPC)
1 ADJUSTING THE POSITION OF THE LINER
The different anatomic shape of riders heads at times requires the position of the hel-
met to be adapted to the head in question. The LINER POSITIONING CONTROL (LPC)
enables the position of the liner to be adjusted. This means that, unlike a standard
helmet, the position of the helmet on the rider's head can be changed without changing
the size of the helmet, making it adaptable to multiple needs.
To adjust the liner, proceed as follows after releasing the rear part of the liner (see
instructions above).
1.1 Release the liner adjustment rear flap from the central locking pin on the rear frame
of the liner (Fig.22).
1.2 Pull the adjustment rear flap and fasten it to the central pin in one of the other 7
possible snap positions.
By pulling the adjustment rear flap of the liner, the helmet is gradually posi-
tioned higher on the head snap after snap.
1.3 Fully reassemble the liner into the helmet (see instructions above) being careful to
correctly insert the adjustment flap into the cavity between the outer shell and the
polystyrene inner shell.
1.4 Put on the helmet and check that the helmet is comfortable and suitably posi-
tioned. If it is not, adjust it again.
WARNING
After adjusting the position of the liner, put on and fasten the helmet to check the correct adjust-
ment of the chin strap (see attached label), the correct positioning of the helmet on your head
in the riding position and the taking off (see "SAFETY AND INSTRUCTIONS FOR USE" above).
INSTRUCTIONS FOR USE
X-1005
23