Operation; Preparatory Activities; Greasing The Splitting Wedge - Zipper Maschinen ZI-HS5TN Instrucciones De Servicio

20 TRANSPORT
For easier transport over short distances, the log splitter is equipped with two wheels and a
transport handle.
21

OPERATION

Never adjust the pressure relief screw! The maximum splitting force of the log
splitter is factory set and the pressure limiting screw is sealed with adhesive to ensure
that the pressure does not exceed the preset maximum. Adjustment was made by a
qualified mechanic using professional instruments. Unauthorized adjustment of the
pressure relief screw may result in serious injury or damage to the machine!
21.1

Preparatory activities

21.1.1 Greasing the splitting wedge

Apply a thin layer of grease to the splitting wedge of your wood splitter before starting work. This
will prolong the life of your tool.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS5TN; ZI-HS7TU
Before moving the log splitter, make sure that the vent screw is tightened!
WARNING
CAUTION
NOTICE
When using a crane for lifting (e.g. when loading
the splitter onto a truck), attach the hoist only to
the intended places - see illustration on the left.
Observe the applicable regulations regarding load
securing!
Never hang the hoist on the transport handle!
Never transport the log splitter when loaded!
To move the log splitter over short distances, hold
it by the transport handle and tilt it slightly - see
illustration on the left.
TRANSPORT
37