Wet/Dry Vac Assembly; Insert Hose - RIDGID WD09700 Manual Del Propietário

Wet/Dry Vac Assembly

1. Line up front of powerhead assembly
with Vacuum port located on the front
of the drum, as shown.
NOTE: Powerhead assembly must be
aligned with drum for proper attachment.
2. Place powerhead assembly on top of
drum.
3. Be sure powerhead assembly
completely covers the top of the drum
so leakage does not occur.
4. Push down on top of handles to cause
flexible locking tabs to hook onto the
drum lip.
5. Make sure that the locking tabs are
snapped into place as shown, to
prevent the lid from coming off.
6. To remove the powerhead assembly,
reverse above directions.
Flexible Locking
Tab Pulled Out
Flexible
Locking Tab
Flexible Locking Tab
(located under latch)
Push
Down to
Latch
Pull
Out to
Unlatch

Insert Hose

Insert the larger end of the hose into the
vacuum port.
Place the utility nozzle securely on the
opposite end of the hose and the vac is
ready for use.
Drum
Power
Assembly
7
Vacuum Port
Power
Assembly
Release
Button