Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6
LEVEL THE RANGE
WARNING
Never completely
remove the leveling leg as the range will not
be secured to the anti-tip device properly.
A. Plug in the unit.
B. Measure the height of your countertop at the
rear of the opening (X).
C. Adjust two rear leveling legs so that the rear
of cooktop is at the same height or higher
than the counter (Y).
D. Slide unit into place.
E. Install oven shelves in the oven and position
the range where it will be installed.
F. Check for levelness by placing a spirit
level on one of the oven shelves. Take two
readings—with the level placed diagonally
first in one direction and then the other.
G. Adjust front leveling legs until the range is
level.
7
INSTALL AND CHECK
ANTI-TIP DEVICE
WARNING
Never completely remove
the leveling leg as the range will not engage
anti-tip device properly. To reduce the risk of
tipping the range, the range must be secured
by a properly installed anti tip bracket.
X
Y
Spirit level
Follow instructions supplied with ANTI-TIP
bracket.
Anti-Tip Bracket
Kit Included
8
FINAL INSTALLATION CHECKLIST
• Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.
• Be sure power is in service to the building.
• Check that all packing materials and tape have been removed. This will include tape on metal
panel under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective
plastic. Failure to remove these materials could result in damage to the appliance once the
appliance has been turned on and surfaces have heated.
• Check that the door and drawer are parallel to each other and that both operate smoothly. If they
do not, see the Owner's Manual for proper replacement.
• Check to make sure the anti tip bracket is installed. Verify the anti tip bracket is working
correctly. Grasp the back of the range, being careful not to grab or bend the rear trim piece. Tilt
the range forward slightly and confirm the anti tip bracket engages the back of the range. If the
anti tip is not present or it is not engaging the range correctly, call 1-800-626-8774 in the US or
1-800-561-3344 in Canada.
• Check to make sure the two rear wall spacers are installed on the back of the range.
OPERATION CHECKLIST
• Check that the oven control operates properly. If the oven control does not operate properly,
recheck the wiring connections.
• Be sure all range controls are in the OFF position before leaving the range.
INSTALLATION INSTRUCTION
31-11134 06-18 GEA
RAS200, RAS240, RAS300
Publicidad
Tabla de contenido
