Publicidad
STX 52
2.1
3.1
1.2
3.2
1.1
3.3
1 – ENTRADAS:
2.4 Fc2: Ajusta a frequência de corte entre as vias MID e
1.1– RCA INPUT: Entradas RCA para Canais Frontais.
HIGH. Atua simultamenamente como fi ltro low pass da via
1.2 – BASS BOOST: Proporciona reforço nos graves.
MID e fi ltro high pass da via HIGH com taxa de atenuação
2 – CROSSOVER:
de 12dB/8°.
2.1 SUBSONIC ON/OFF: Habilita e desabilita o fi ltro
3 – VIA FLAT:
subsônico de 24dB/8°. Pressionada realiza o corte das
frequências abaixo do valor selecionado na (chave 2.2),
3.1 ON/OFF: Chave Liga e Desliga da via FLAT.
solta mantém o sinal FLAT.
3.2 LEVEL: Ajuste de nível da via FLAT.
2.2 FREQUENCIAS SUBSONIC: Chave para seleção
3.3 RCA FLAT: Saídas RCA da via FLAT STEREO
da frequência de corte do fi ltro subsônico.
(FULL RANGE).
2.3 Fc1: Ajusta a frequência de corte entre as vias LOW e
MID. Atua simultamenamente como fi ltro low pass da via
4 – VIA LOW:
LOW e fi ltro high pass da via MID com taxa de atenuação
4.1 ON/OFF: Chave Liga e Desliga da via LOW/REAR.
de 12dB/8°.
4.2 LEVEL: Ajuste de nível da via LOW/REAR.
1 – INPUT:
2.4 Fc2: Adjusts the cut-off frequency between MID and
1.1 RCA FRONT IN: RCA input for front channels.
HIGH. Simultaneously it acts as low pass fi lter of the MID
1.2 BASS BOOST: Reinforces the bass notes.
path and high pass fi lter of the HIGH path with attenuation
rate of 12dB/8º.
2 – CROSSOVER:
2.1 SUBSONIC ON/OFF: Enables and disables the
3 – FLAT WAY:
24dB/8º subsonic fi lter. Pressing cuts the frequencies
3.1 ON/OFF: On/Off Switch for FLAT way.
below the value selected in (key 2.2), loose holds the FLAT
3.2 LEVEL: Adjust the level of the FLAT way.
3.3 RCA FLAT: Output RCA output for the FLAT STE-
signal.
2.2 SUBSONIC FREQUENCIES: Key for selection of the
REO way (FULL RANGE) .
cutoff frequency of the subsonic fi lter.
2.3 Fc1: Adjusts the cut-off frequency between the LOW
4 – LOW WAY:
and MID ways. It simultaneously acts as low pass fi lter of
4.1 ON/OFF: ON/OFF switch for LOW/REAR way.
4.2 LEVEL: Adjust the level of the LOW/REAR way.
the LOW route and high pass fi lter of the MID path with
attenuation rate of 12dB/8º.
4.3 RCA LOW/REAR: Output RCA output for the LOW/
attenuation rate of 12dB/8º.
1 – INPUT:
2.4 Fc2: Adjusts the cut-off frequency between MID and
1.1 RCA FRONT IN: RCA input for front channels.
HIGH. Simultaneously it acts as low pass fi lter of the MID
1.2 BASS BOOST: Reinforces the bass notes.
path and high pass fi lter of the HIGH path with attenuation
rate of 12dB/8º.
2 – CROSSOVER:
2.1 SUBSONIC ON/OFF: Enables and disables the
3 – FLAT WAY:
24dB/8º subsonic fi lter. Pressing cuts the frequencies
3.1 ON/OFF: On/Off Switch for FLAT way.
below the value selected in (key 2.2), loose holds the FLAT
3.2 LEVEL: Adjust the level of the FLAT way.
signal.
3.3 RCA FLAT: Output RCA output for the FLAT STE-
2.2 SUBSONIC FREQUENCIES: Key for selection of the
REO way (FULL RANGE) .
cutoff frequency of the subsonic fi lter.
2.3 Fc1: Adjusts the cut-off frequency between the LOW
4 – LOW WAY:
and MID ways. It simultaneously acts as low pass fi lter of
4.1 ON/OFF: ON/OFF switch for LOW/REAR way.
the LOW route and high pass fi lter of the MID path with
Frequency Locked
2.2
2.3
2.4
4.1
5.1
6.1
4.2
5.2
6.2
4.3
5.3
6.3
4.3 RCA LOW/REAR: Saídas RCA da via LOW/REAR
(LOW PASS).
5 – VIA MID:
5.1 ON/OFF: Chave Liga e Desliga da via MID.
5.2 LEVEL: Ajuste de nível da via MID.
5.3 RCA MID: Saídas RCA da via MID.
6 – VIA HIGH:
6.1 ON/OFF: Chave Liga e Desliga da via HIGH.
6.2 LEVEL: Ajuste de nível da via HIGH.
6.3 RCA HIGH: Saídas RCA da via HIGH (HIGH PASS).
REAR way (LOW PASS).
5 – MID WAY:
5.1 ON/OFF: On/Off switch for MID way.
5.2 LEVEL: Adjust the level of the MID way.
5.3 RCA MID LOW: RCA output for the MID way.
6 – HIGH WAY:
6.1 ON/OFF: On/Off switch for HIGH way.
6.2 LEVEL: Adjust the level of the HIGH way.
6.3 RCA HIGH: RCA output for the HIGH way (HIGH
PASS).
4.2 LEVEL: Adjust the level of the LOW/REAR way.
4.3 RCA LOW/REAR: Output RCA output for the LOW/
REAR way (LOW PASS).
5 – MID WAY:
5.1 ON/OFF: On/Off switch for MID way.
5.2 LEVEL: Adjust the level of the MID way.
5.3 RCA MID LOW: RCA output for the MID way.
6 – HIGH WAY:
6.1 ON/OFF: On/Off switch for HIGH way.
6.2 LEVEL: Adjust the level of the HIGH way.
6.3 RCA HIGH: RCA output for the HIGH way (HIGH
PASS).
•CONEXÕES DE ÁUDIO / AUDIO CONNECTIONS / CONEXIÓN DE AUDIO
Os Crossovers da linha STX tem a fi nalidade de direcionar faixas de freqüências do espectro de áudio para amplifi cadores, que por sua vez amplifi carão e direcionarão
os sinais aos transdutores acústicos (alto-falante) específi cos, proporcionando um sistema de sonorização muito mais efi ciente, ótimo desempenho e uma ampla
possibilidade de projetos.
The STX Line Crossovers was developed to send a range of audio frequencies to amplifi ers, which in turn amplify the frequencies and send them to specifi c acoustic
transducers (loudspeakers). In this way the Crossover provides an effi cient sound system, great performance and a wide array of possibilities.
Los Crossovers de la línea STX tienen el propósito de dirigir bandas de frecuencias del espectro de audio a amplifi cadores, que a su vez amplifi car y dirigir las señales
a los transductores acústicos (altavoz) específi cos, proporcionando un sistema de sonorización mucho más efi ciente, óptimo desempeño Y una amplia posibilidad de
proyectos.
Exemplo / Exemple / Ejemplo STX 82 Frequency Locked:
FUSE 1A
+BAT 12V
GND
GND
BATTERY
12V
CD/MP3/DVD-PLAYER
/STETSOMBRASIL
SAC: 30031900
www.STETSOM.com.br
MADE IN BRAZIL
Publicidad
