Princess 01.219600.01.001 Manual De Usuario página 6

Instruction manual
• After each cycle, the accumulated water and impurities in the filter
cover, the lower one way valve and the cup cover should be removed.
• Note that the water temperature must not exceed 40°C.
• Note that the blade unit (under the jar) must be tightened, otherwise
there may be air leakage.
• Vacuum function: After selecting this function, the machine will start
to vacuum. When the negative pressure in the cup reaches the
desired vacuum, the air pump stops vacuuming. The program will then
end and the blender will enter the standby modus. If there is air
leakage or the seal is not tight, the blender will continue to pump for 70
seconds. If the negative pressure in the cup has not reached the
standard value, there will be a flashing indicator light and a buzzer
alarm, please check then the seal before continuing. This function can
be stopped when the button is pressed again or the knob is turned to
OFF during program execution, the program will not stop or switch if
any of the other function buttons are being pressed during program
execution. After the program ends, first press the switch to open the
release handle, then unlock the cup from the body, press the vent
button on the vacuum lid until you don't hear the airflow sound
anymore. The vacuum lid can now be removed from the jar.
Note:
• Pay attention to place the lid correct on the jar before starting to
vacuum. The pouring nozzle of the vacuum lid should be completely
covered by the sealing ring, otherwise there may be air leakage!
• Note that the blade unit (under the jar) must be tightened, otherwise
there may be air leakage.
• Pulse function: This function is a pulse program. The motor runs at
the highest speed. Press and hold down the pulse button in this
position, not longer than 2 minutes, due to possible overheating of the
6
engine. The indicator light will turn on until you release the button.
Allow the unit to cool down before further use. When finished, first
press the switch to open the release handle and then unlock the cup
from the body.
• Min~Max blending function: Turn the knob to the right to set the
desired speed, the min position is the lowest speed and the max
position is the highest speed. The speed indicator bar will light up
accordingly. After 2 minutes and 30 seconds the program ends and
the blender enter the standby modus. Press the switch to open the
release handle and then unlock the cup from the body.
After three minutes with no operations after entering the standby mode, all
the indicators will go out and the blender will enter sleep state. At this time,
press any button to go back to the standby mode.
When the machine is not in use, please turn the knob to the OFF position,
unplug the power plug and store it in a clean, dry indoor location.
ENVIRONMENT
This appliance should not be put into the domestic garbage at the
end of its durability, but must be offered at a central point for the recycling
of electric and electronic domestic appliances. This symbol on the
appliance, instruction manual and packaging puts your attention to this
important issue. The materials used in this appliance can be recycled. By
recycling of used domestic appliances you contribute an important push to
the protection of our environment. Ask your local authorities for information
regarding the point of recollection.
Support