Salvador Escoda MUCSW-16-HG Manual De Instalación Y Funcionamiento página 39

4) Installation location
1. Do not install the unit in rooms where flammable gas or alkaline or acid substance are present
(kitchens or workshops etc.). The performance will be affected, and unit components like coils,
plastics, etc. will be damaged irreparably.
2. To install unit in the center of room if possible, by using a stacker and inserting a plywood sheet
between the unit and the elevated stacker.
3. Be sure the installation location has sufficient strength to carry the weight of the unit. The air inlet
grille and air discharge louvers are not obstructed and the treated air is able to blow all over the room.
4. Ensure to have sufficient space for maintenance and servicing operations.
5) Installation to the ceiling
1. To mark the position of suspension rods, water pipes and
condensate drain hose, power supply cables, etc.
2. To fix the suspension rods on the cement or wooden ceiling.
3. To lift the unit and fit 4 mounting brackets to the threaded rods.
When lifting the unit body into position, take care by its four
corners. Do not lift unit by the condensate drain pipe or by the
coil connections.
4. Adjust unit position and the distance between the unit body and
the lower part of the false ceiling.
5. Ensure the unit is horizontally level, otherwise condensate water
can not drain properly. Then, tighten nuts and counter nuts. The
rods should have two nuts and washers to lock the unit in
position. The mounting brackets will then hook over the
washers.
6. After the connection of condensate drainage piping, inlet and
outlet water piping, to check again and ensure the unit is level.
15