VONROC ET502AC Traducción Del Manual Original página 7

Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3.
1. Reload lever
2. Cartridge shaft
3. Switch
4. Lock on button
5. Top
6. lock off button
7. Cartridge filling level window
8. Safety pin
3. OPERATION
Application (Fig. B)
For this tool, use one of the following length for
staples or nails:
• Staples: 6 up to 14 mm
• Nails: 15 mm
Loading the nails or staples (Fig. 3)
• Choose the correct nail or staple for the job.
• Hold the tacker with bottom upwards.
• Open de cartridge shaft (2) by slightly pressing
the reload lever (1)
• Pull the reload lever backwards to open the
cartridge shaft(2).
For nails:
• Place the nails upside down against the left side
of the cartridge shaft (2). The left side also shows
a nail-symbol on the cartridge shaft, see fig.4
WWW.VONROC.COM
For staples:
• Place the staples upside down in the cartridge
shaft (2).
• Push the reload lever to fully close the cartridge
shaft.
Before loading the tacker, make sure the
machine is in lock on position and it is
disconnected from the mains supply.
Never load staples and nail at the same time.
Checking the cartridge shaft
The cartridge filling level window (7) indicates the
amount of staples/nails inside the cartridge shaft.
Using the tacker
After every load test the machine on a piece
of scrape.
• Press the Lock Off switch (6) to unlock the
machine.
NOTE: The machine does not work when Lock on
switch (4) is pressed. Even though connected to
the mains supply.
• Press the lock On switch (4) to lock the machine.
NOTE: When not in use, press the lock On switch
to lock the machine and disconnect from the
mains supply.
NOTE: Always store in Lock on (4) position.
Placing the tool
1. Place the tool on workpiece at the spot where
the staple or nail should be located.
2. Press the tool down firmly by pressing the ma-
chine on the top (5) with one hand.
3. Use your other hand to operate the switch (3).
4. By pressing the machine down firmly you lift the
safety of the machine.
Warning! The safety of the machine will be
lifted when pressure is applied to the safety
pin (8) on the bottom of the machine.
Always make sure the tacker mouth is in
direct contact with the material when
pressing the switch.
EN
7