IKEA FIXA Manual Del Usuario página 10

in EN 60745. It may be used to compare
one tool with another and as a preliminary
assessment of exposure to vibration when
using the tool for the applications mentioned
in this manual. However, using the tool
for different applications, or with different
or poorly maintained accessories, may
significantly increase the exposure level.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off or
when it is running but not actually doing
the job, as this may significantly reduce the
exposure level over the total working period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm, and
organising your work patterns.
ASSEMBLY
Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage, set the
selector for rotation right/left to the
centre position. Unintentional actuation of
the trigger can lead to injuries.
Battery charging
Charging your screwdriver/drill
When the charger is connected to the
electricity supply, the red diode on the
screwdriver/drill lights up. The diode lights
up while the battery is being charged (8).
Under normal conditions of use the
screwdriver can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the screwdriver has been charged for test
purposes only and must be fully charged
before first time use.
First read the safety instructions and then
follow the loading instructions. Insert
the charger plug into the socket in the
screwdriver/drill. Then connect the charger
to the electricity supply.
Make sure that there are no knots or sharp
bends in the cable.
The charger's transformer and the battery
have been designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers.The battery will gradually
lose its charge over a period of time, even if
the tool is not used.
The lithium-ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the machine is switched off by
means of a protective circuit: The tool no
longer rotates.
WARNING! Do not continue to
press the forward/reverse switch after
the machine has been automatically
switched off. The battery can be damaged.
WARNING! Recharge the battery
on a non-flammable surface. Do not
recharge the battery for more than
eight hours. The red diode will go out
when the battery has been fully loaded.
Disconnect the cable and store the charger
in a suitable place when it is not in use.
It is not advisable to recharge the battery in
temperatures below freezing.
8