Safety And Warning Information; Safety Guidelines; Important Safety Instructions - Campbell Hausfeld PW2802 Manual De Instrucciones De Operación Y Lista De Partes

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pressure Washer

Safety and Warning Information

Safety Guidelines

This manual contains information that is very important to
know and understand. This information is provided for
SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help
recognize this information, observe the following symbols.
which, if not avoided, WILL result in death or serious injury.
not avoided, COULD result in death or serious injury.
not avoided, MAY result in minor or moderate injury.
may cause damage to equipment.
NOTE: Information that requires special attention.

Important Safety Instructions

SAVE THESE INSTRUCTIONS
When using this product, basic precautions should always be
followed, including the following:
1. Read all instructions before using the product.
2. To reduce the risk of injury, close supervision is necessary
when the product is used near children.
3. Follow all safety codes as well as the Occupational Safety
and Health Act (OSHA).
4. Ensure safety devices are operating properly before each
use. DO NOT remove or modify any part of the gun or unit.
5. Know how to stop this product and bleed pressure quickly.
Be thoroughly familiar with the controls.
6. Stay alert – watch what you are doing.
7. Do not operate the product when fatigued or under the
influence of alcohol or drugs.
8. Keep operation area clear of all persons.
9. Do not overreach or stand on unstable support. Keep good
footing and balance at all times.
10. Follow the maintenance instructions specified in the
manual.
not discharge streams at persons. This product is to be used
only by trained operators. Always remove lance from gun
before cleaning debris from tip.
Keep clear of nozzle. NEVER direct high pressure spray at
a person, animal, or yourself.
Always wear safety glasses or goggles and protective
equipment (hearing protection, gloves, rubber boots,
protective clothing) when operating or performing
maintenance.
Never put hand or fingers over the spray tip while
operating the unit.
Never try to stop or deflect leaks with any body part.
Always engage the trigger safety latch in the safe
position when spraying is stopped even if only for a few
moments.
www.chpower.com
Danger indicates an
imminently hazardous situation
Warning indicates a potentially
hazardous situation which, if
Caution indicates a potentially
hazardous situation which, if
Notice indicates important
information, that if not followed,
Risk of injection or severe
injury. Keep clear of nozzle. Do
Always follow detergent manufacturer's label
recommendations for proper use of detergents. Always
protect eyes, skin, and respiratory system from detergent
use.
of any of the parts (hoses, fittings, etc.) in the pressurized
system. Ensure all equipment and accessories are rated to
withstand the maximum working pressure of the unit.
NEVER spray flammable liquids or use pressure washer in
areas containing combustible dust, liquids, or vapors.
Never operate this machine in a closed building or in or
near an explosive environment.
Do not remove fuel tank cap or fill fuel tank while engine
is hot or running (allow engine to cool two minutes
before refueling). Always fill the tank slowly.
Never disconnect the high pressure discharge hose from
the machine while the system is pressurized. To
depressurize machine, turn power and water supply off,
then press the gun trigger 2-3 times.
Never permanently engage the trigger mechanism on the
gun.
Never operate the machine without all components
properly connected to the machine (handle, gun/wand
assembly, nozzle, etc.).
ALWAYS turn water supply "ON" before turning pressure
washer "ON." Running pump dry causes serious damage.
Do not operate the pressure washer with the inlet water
screen removed. Keep screen clear of debris and
sediment.
NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace
worn or damaged parts immediately.
Use only the nozzle supplied with this machine.
Never leave the wand unattended while the machine is
running.
Never tamper with the engine governor or attempt to
alter factory settings. Altering factory settings could
damage the unit and will void the warranty.
Always hold gun and wand firmly when starting and
operating the machine.
NEVER allow the unit to run with the trigger released
(off) for more than one minute. Resulting heat buildup
will damage the pump.
NEVER store the pressure washer outdoors or where it
could freeze. Freezing temperatures can seriously damage
the pump.
Release the trigger when changing from high to low
pressure modes. Failure to do so could result in damage
to the nozzle.
cause injury. Examine hoses regularly and replace if
damaged. Do not attempt to mend a damaged hose.
4
Do not use pressure that
exceeds the operating pressure
Explosion hazard.
Equipment damage.
Keep hose away from sharp
objects. Bursting hoses may

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Pw3002

Tabla de contenido