R R R R R Egulatory Information Egulatory Information - U.S.Robotics SureConnect 9000 Guía De Instalación Rápida

R R R R R egulatory Information egulatory Information egulatory Information egulatory Information
egulatory Information
Manufactur Manufacturer's Declar Manufactur er's Declar er's Declarations of Conformity er's Declar
Manufactur Manufactur er's Declar
FCC Declar FCC Declaration of Conformity FCC Declar ation of Conformity ation of Conformity ation of Conformity
FCC Declar FCC Declar ation of Conformity
We declare under our sole responsibility that the U.S. Robotics SureConnect ADSL USB Modem
to which this declaration relates, is in conformity with the following standards or other normative
documents:
ANSI C63.4-1992 Methods of measurement
Federal Communications Commission 47 CFR Part 15, subpart B
1) 15.107 (e) Class B Conducted Limits
2) 15.109 (g) Class B Radiated Emissions Limits
FCC Class B S FCC Class B S tatement tatement
FCC Class B Statement FCC Class B S FCC Class B S tatement tatement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
this device may not cause harmful electromagnetic interference, and
this device must accept any interference received including interference
that may cause undesired operations.
R R R R R adio and adio and adio and T T T T T elevision Interfer adio and elevision Interfer elevision Interfer
adio and elevision Interference elevision Interfer
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
and uses radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference
to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
Reorient or relocate the receiving antenna or cable input device.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The user may find the following information prepared by the Federal Communications Commis-
sion helpful:
T T T T T elephone Interfer elephone Interfer elephone Interference Bulletin. elephone Interfer elephone Interfer ence Bulletin. ence Bulletin. ence Bulletin. ence Bulletin.
This document is available on the Internet through the FCC Consumer Information Bureau Home
Page at http://www.fcc.gov/cib. Under Consumer Information Directory> Telephone > Miscel-
laneous Telephone Information, select Interference to Telephones.
Caution Caution
Caution Caution Caution: Changes or modifications not expressly approved by the party responsible for compli-
ance could void the user's authority to operate this equipment.
In order to maintain compliance with the limits of a Class B digital device, US Robotics requires
that you use a quality interface cable when connecting to this device. Suggested cable type is 90-
ohm USB cable for the USB port, and standard telephone cable for the RJ-11 port, 26AWG.
U U U U U L L L L L Listing/C-U Listing/C-UL L L L L Listing Listing/C-U Listing/C-U Listing Listing
Listing/C-U Listing Listing
This information technology equipment is UL Listed and C-UL Listed for both the US and
Canadian markets respectively.
ations of Conformity ations of Conformity ations of Conformity
ations of Conformity
ence ence
ence ence
23 23 23
23 23