Blue Connect Manual Del Usaurio página 132

Declaration of conformity FCC
Changes or modifications not expressly approved by
Riiot Labs SA could void the user's authority to operate
the equipment.
For devices with a serial number that begins with a 4.
FCC Part 15 compliance statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation. NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct interference by one or more of
the following measures: - Reorient or relocate the receiving
antenna. - Increase the separation between the equipment
and receiver. - Connect the equipment into an outlet on
circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Industry Canada Licence-Exempt Radio Apparatus
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Radio Frequency (RF) Exposure Compliance of
Radiocommunication Apparatus
To satisfy FCC and IC RF Exposure requirements for mobile
devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons
during operation. To ensure compliance, operation at closer
than this distance is not recommended. This transmitter must
not be co-located or operating in conjunction with any other
antenna or transmitter.
Conformité à l'exposition aux champs RF des équipements
radio
Pour satisfaire aux exigences FCC et IC concernant
l'exposition aux champs RF pour les appareils mobile, une
distance de séparation de 20 cm ou plus doit être maintenu
entre l'antenne de ce dispositif et les personnes pendant le
fonctionnement. Pour assurer la conformité, il est déconseillé
d'utiliser cet équipement à une distance inférieure.
Cet émetteur ne doit pas être co- situé ou fonctionner
conjointement avec une autre antenne ou un autre émetteur.
Declaration of conformity CE
For devices with a serial number that begins with a 3.
Hereby, Riiot Labs S.A. declares that the radio equipment
type Blue Connect Smart Pool Analyser is in compliance with
Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following internet address:
www.blueconnect.io/legal
SIGFOX : Tx : 868.13MHz / 14dBm max Rx : 869.525MHz
Bluetooth LE : 2400-2483.5MHz / 10dBm max
Authorized countries codes:
ALB – AND – AUT – BEL– BIH – BLR – BUL – CYP – CZE –
DNK – EST – FIN – GRC – HNG – HOL – HRV – IRL – ISL –
LIE – LTU – LUX – LVA – MDA – MKD – MLT – MNE – NOR –
POL – POR – ROU – SRB – SUI – SVK – SVN – TUR
blueconnect.io
22
Riiot Labs S.A.