Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If you are using the long side, centre the notches on the side of the base in such
as way as to obtain the correct alignment and functioning capacity of the magnet.
If you are using the short side, align the magnet and the detector itself.
8.
Using the screws or the adhesive tape, attach the magnet.
9.
Remove the battery tab.
10. Re-attach the cover to the base of the contact and replace the enclosure
screw.
11. Enroll the device.
The Air2 requires enrolling only.
If it becomes necessary to replace the device cover or battery, work through the
following steps.
1.
Remove the enclosure screw on the back of the remote-control key and open
the device.
2.
Remove the cover.
3.
Replace the cover/battery as required.
4.
Close the device and replace the enclosure screw.
5.
Enroll the remote-control key.
1.
Choose a suitable mounting placement.
2.
Hold the base to the chosen mounting placement and mark the screw loca-
tions.
3.
Insert the battery, ensure you respect the proper polarity.
4.
Attach the battery cover.
5.
Refer to Figure 6 - Air2-FD100, b, page 115.
Position the detector over the base and, with minimum force, turn it clock-
wise until notch "A" aligns with notch "B" (in order to attach the detector to
the base); turn it still further until notch "A" aligns with notch "C" (in order
to allow the base to close the tamper microswitch).
6.
Enroll the device.
During the enrolling phase the Air2-BS200 wireless transceiver is integrated into
the Inim intrusion control panel by simulating:
•
a reader, with the address programmed via the module itself (ADD), by means of
buttons P1 and P2 on the PCB;
•
up to 10 expansion boards, at addresses ADD, ADD+1, ... ADD+9, capable of
managing the terminals configured via the project template.
The address must be set during the programming phase of the reader. During this
phase the address is indicated by LEDs DL 1-4 in accordance with the following:
Reader
LED DL1
address
- red
1
0
2
0
3
0
4
0
5
0
6
0
7
0
8
1
9
1
10
1
14
Installing the Air2 remote-
Installing the Air2-FD100
Addressing the Air2-BS200
Table 18: Panel notifications
LED DL2
LED DL3
LED DL4
- blue
- green
- yellow
0
0
0
1
0
1
1
0
1
0
1
1
1
1
0
0
0
0
0
1
control key
1
0
LED Off
0
1
LED On
1
L
Flashing LED
0
1
0
1
0
1
0
Wireless accessories
Note
4-4
4-5
4-6
Installation
Publicidad
Tabla de contenido
