Publicidad
Idiomas disponibles
Idiomas disponibles
MOWER DECK LEVEUNG
A WARNING
Before checking
mower, shut off PTO and engine.
Atiow atl moving
parts to stop. Remove ignition
key, then disconnect
the spark plug wire and
fasten it away from the spark pJug.
Side
to Side
Leveling
ufthe cut is uneven, the mower may need UeveHng,
UnequaU or improper tire pressure may ado cause an
uneven cut, See CHECK TURE PRESSURE,
1, With the mower installed, pUacethe rider on a
smooth, UeveU surface such as a concrete floor, Turn
the front wheeUs straight forward, Turn the engine off,
set the ground speed controU Ueversto PARK, and
wait for aH moving parts to stop,
2, Check for bent bUades and repUace if necessary,
3, Check the tire pressures, See CHECK TURE PRES-
SURE,
4, Set the cutting height to mid position, Arrange the
mower bUades so that they are pointing from side-to-
side (Figure 38),
5, Measure the distance between the tips of the outside
blades and the ground (Figures 37 & 38), If there is
more than 1/8" (3mm) difference between the meas-
urements on each side, proceed to step 6, If the dif-
ference is 1/8" (3mm) or less, proceed to Front To
Back Leveling,
6, See Figure 39, Loosen the outside nut (A) and taptite
screw (C), then turn the eccentric nut (B) to raise or
lower the left side of the deck, When the mower deck
is level, hold the eccentric nut while tightening the
outside nut, Tighten the taptite screw (C),
\
Figure 37. Measure Blade Tips to Ground
A. Mower Deck
B. Blade Tip
C. Levet Ground
Figure 38. Orient Btades Side-to-Side
Figure 39. Side-to-Side
Adjustment
A. Outside Nut
B. Eccentric
Nut
C. Taptite Screw
3O
Publicidad
