Kenmore 911.41775 El Manual Del Propietario página 23

Tosave you4ime and money_- b efore makinga.seryice callcheck the list belowlfor any
problem you may feel.you,havewith the performance of,your rang e_ If the problem-is -
something you cannot fix use the Consumer Service Numbers located at the-back of this
manuaf. When making any calls have the Model No., Repair Parts list,
Use and Care Manual and the Date of Purchase available.
PROBLEM POSSIBLE CAUSE
The displayofyour Range malfuncti0n.
control is flashing ......
"F" follO_vedby a
number or letter:
• • •ii ii • ii
Oven and oven No power to range,
control will not
work.
POSSIBLE SOLUTION
Press the CLEAR/OFF
pad. Let the oven cool for
I hour and enter an oven
or cleaning operation. If
code repeats, call for
service.
Check the circuit breaker
or fuse. Make sure the
power cord is plugged in.
ii i i i
Oven temperature, Thermostat Calibration.
seems inaccurate.
ii i
See the adjustments
described following this
section.
iii i i
Oven will not Clean cycle is not
unlock, finished.
Oven temperature must
drop below the lock
temperature before the
door will unlock.
Oven light will not- a, Light switch in off a. Check oven light
work, position, switch on the control
panel.
b. Oven rlightbulb b. Check the oven light
burned out, buib. .
Oven did not
clean or results
were poor.
i
a. Controls were not set
properly.
b. Clean cycle was
interrupted.
c. Oven was soiled
heavily,
a. Check the self-cleaning
section of this manual
b. The normal clean cycle
should last 4 hours.
c. Heavy spillovers
should be removed
before the cycle is set.
You can also repeat
the cycle.
3"