auna multimedia 10028699 Manual De Instrucciones página 13

CAUTION: Make sure that the plug is not inserted when assembling the device!
• Remove all objects from the cupboard and anything which is fragile in the adjacent cupboards.
• For the installation the cupboard must fulfil the following conditions:
• Thickness of the cupboard floor between 16 mm and 20 mm.
• The wall mounting of the cupboard must be stable and anchored firmly in the wall with at least
2 screws.
• Important! Do not install the device above a cooker!
• When installing the device it must be ensured that there is a power socket within reach.
• The mains socket must be within easy reach, so that the plug can be quickly removed in an emergency
• Important! Do not connect the device to the mains power supply until after installation!
• The device cannot be installed under cupboards under which there is a lighting strip.
• For mounting, you may need the following supplies: A drill with 6 mm drill bit, pilot drill or nail, Allen
key, tape measure, adhesive tape, scissors, safety goggles.
MOUNTING PROCEDURE
Supplied mounting accessories: 4 Screws; 4 Spacers;.
• Please adhere to the dimensions stated in the installation instructions.
• You should use only the installation accessories supplied.
STEP 1: With the help of a gimlet or nail pierce the crosses at the attachment points and use it to mark the
holes.
STEP 2: Drill the holes into the wall cupboard.
STEP 3: Insert the spacers into the holes provided on the device. NOTE: Sufficient ventilation is only gua-
ranteed with a spacer.
STEP 4: Countersink the screws into the holes in the cupboard, using the 4 screws and the spacers, attach
the kitchen radio to the bottom of the cupboard. Tighten the screws hand-tight with an Allen key. CAUTION:
Use a wrench and not an electric screwdriver.
Use the 4pcs rubber feet provided and stick 1pc each on the 4 corners of the bottom of the unit. In
this case, the unit can be use as an independent sound system on the table without under-cabinet.
13