Erreka CICLON CLS210F Guía Rápida De Instalación Y Programación página 7

1 Mount the operator (1) on the bracket (2) using the
screws and washers supplied (3).
Then mount the unit on the wall.

Remember that the bracket corresponding to models
CLS210F/ CL210F (T2000VFI) / CL210 is shown.
The bracket for models CLS250F/ CL250F/ CL250 has
some differences, although assembly is carried out in a
similar way.
A1 Mount the drag wheel (1) on the
operator shaft.
A2 Install the arm (2) and the cap (3)
on the drag wheel.
B1 Mount the drag wheel (1) on the operator shaft.
B2 Install the arm (2) and the cap (3) on the drag
wheel.
OPTION A: assembly with sliding arm
A3 Close the gate and mark position A
on it.
Open the gate and mark position B
on it.
Secure the track so points A and B
are aligned inside.
3
P246D
OPTION B: assembly with articulated arm
3
P246G
Assembly
P246E
B3 Close the gate, pull the arm (1) a maximum of
670 mm and mark the positions A and B. Secure
the bracket (2) in this position.
P246A
A4 Position the closing and opening
limit switches (1) on the track using
the plate (2) (the opening limit
switch is shown in the figure).
P246F
P246H
7