SR 40 SINGLE-Hex:Layout 1
1
2
3
5
6
1. Check that the AC mains voltage stated on the included power supply is identi-
cal to the AC mains voltage available where you will use your system. Using the
power supply with a different AC voltage may cause damage to the unit.
2. Point the antenna (2) upward.
3. Plug the feeder cable on the included power supply into the DC ONLY socket (10) on the
receiver.
4. Bend part of the feeder cable into a small bight, pass the bight through the strain relief
(9) from above, and slip the bight over the hook on the strain relief (9). Tighten the cable.
5. Plug the AC adapter into a convenient power outlet.
6. To switch power to the receiver on, press ON/OFF (1). To switch power to the receiver
off, press ON/OFF (1) again.
1. Move the transmitter around the area where you will use the system to check the area
for "dead spots", i.e., places where the field strength seems to drop and reception de-
teriorates.
If you find any dead spots, try to eliminate them by repositioning the receiver. If this does
not help, avoid the dead spots.
SR 40 SINGLE
01/21/2008
10:42
10
4
Seite 17
(Schwarz/Black Auszug)
3 Setting Up
3.4 Connecting
the Receiver to Power
Fig. 5: Connecting to power.
L
Refer to fig. 5.
3.5 Before the
Soundcheck
17