Niagara SINGLE FLUSH Instrucciones De Instalación, Guía De Solución De Problemas Y Garantía página 3

4a. FOR CERAMIC BOLT COVERS (N7711)
Make sure that the bolt cover area of the toilet is clean and dry. Use a dry piece of cloth or soap and water, if needed. Remove protective
film from one side of Velcro and place on back of ceramic cover plate, vertically approximately ½" from the edge of the plate (2 strips
per plate). Remove the remaining protective film from Velcro strips. Position bolt cover on toilet. If everything is aligned, press firmly so
it remains in place. Repeat for second bolt cover on opposite side of the toilet.
To finish, smooth off a bead of sealant around the plates. Remove excess sealant. After 24 hours, the bolt cover adhesive should be
completely set. If needed to remove bolt cover, gently pry off and be sure to clean off old adhesive.
5.
6.
FLUSH BUTTON
SIDE HANDLE
4. BOLT COVER INSTALLATION FOR SKIRTED BOWLS
Take out the bolt covers with the buckle of the bolt cover facing up. Make sure both ribs on
the back of the bolt cover align with the ceramic cut out on the toilet. Put the top of buckle into
ceramic cut out then slide in the bolt cover from bottom to top - making sure everything is
aligned. Install the other bolt cover the same way.
Disassembly (No tools necessary):
To remove the bolt cover, pry off the bottom of bolt cover from the toilet by hand. Do not pry
from the top. Lift the side plate from the bottom and remove. Disassemble the other side plate
in the same way.
TOILET TANK INSTALLATION
The tank has been factory assembled; confirm rubber sealing gasket is in position on the bottom of the tank.
Place the tank on the toilet bowl. Secure the tank in place with the two (2) washers and (2) nuts provided.
DO NOT OVERTIGHTEN.
Open the shut-off valve slowly and check for leaks. Fill to the water line. Adjust the level, if necessary by
turning the black screw on top of the float. Turn the screw to the right (clockwise) to raise the water level or
to the left (counter clockwise) to lower the water level.
FLUSH BUTTON OR SIDE HANDLE INSTALLATION / ADJUSTMENT
FLUSH BUTTON: The flush button has been factory assembled in the tank lid. Secure the flush button
mechanism into the tank lid by hand tightening the lock nut. The bottom of the push rod(s) leading from the
flush buttons should be slightly backed off from the top of the flush valve.
To increase the rod length, turn the rod locknut counter-clockwise to loosen, then rotate the push rod
counter-clockwise to increase exposed length. When desired length is achieved turn the rod locknut
clockwise, while holding the push rod, till it is tightened.
To shorten the rod length, turn the rod locknut counter-clockwise to loosen, then rotate the push rod
clockwise decrease exposed length. When desired length is achieved turn the rod locknut clockwise,
while holding the push rod, till it is tightened.
NOTE: When activating the half flush mode, both buttons on the flush mechanism will depress. When activating the full flush mode
(chrome button), only the chrome button will depress. The flush valve mechanism is setup to prevent the full flush from being activated
when the green button is pushed. It's important that the flush rods have equal clearance to assure proper function of the half flush.
SIDE HANDLE: Insert handle through opening in side of tank with handle extension facing forward.
Place rubber washer, then plastic washer on threaded extension from handle inside of tank. Hand-tighten lock
nut by rotating counter-clockwise (left-handed thread).
While holding handle level, connect cable box from flush valve. Position cable box so rounded corner is in
top, front position. Hand-tighten lock nut onto handle threaded extension by rotating counter-clockwise (left-
handed thread). Check handle movement to assure proper connection with flush valve.