The Safe2Go Car Seat; The Maxi-Cosi Car Seat - Mutsy igo Manual De Instrucciones

English
· Place the rain cover from top to bottom
over the pushchair and make sure that
the rain cover is attached well behind the
back support and over the leg support.
The 5-point safety harness (w1, w2)
· Place your child in the pushchair and
make sure that the legs of your child are
placed on each side of the leg piece.
· Make sure that the hip and shoulder
belt is positioned correctly over your
child and place both plastic clamps in
the central part of the harness attached
to the leg piece (w1).
· To adjust the length of the shoulder
straps, loosen the shoulder protectors
from the belt by undoing the velcro.
This will reveal the belt buckles. Adjust
the length by sliding the buckles along
both shoulder straps until your child is
comfortably secure.
press down the velcro on both sides to
relock the shoulder protectors in place.
· The back support contains three posi-
tions for the shoulder belts. To adjust
the position, open the panel behind the
back support (w2). Loosen the shoulder
belts by moving the attachment rings
through the openings. Move the attach-
ment rings through the desired openings
so that the shoulder belts are positioned
properly and click the panel back.
· Regularly check the length and position
of the belts and adjust, where necessary.
safe2go car seat (up to 13 kg / 29 lbs)
· Make sure that the chassis has fully
been unfolded and the brake blocked
during all actions indicated below.
Installing the safe2go adapters to the
frame (x1)
· The adapter marked with 'R' is placed on
the right side of the chassis, the adapter
marked 'L' is placed on the left side.
18
After adjusting,
· Slide the adapters in the attachment
parts and press solidly until you hear
a click. Check the adapters by trying to
remove them from the chassis.
Place the safe2go car seat
· Orientate the Safe2go car seat such
that it is directed rearwards on the
chassis. Hold the Safe2go car seat with
the central hinge points of the support
bar directly above the adapters. Lower
the Safe2go car seat and press solidly
into the adapters until you hear a click.
Check that the Safe2go car seat has
been placed horizontally and has been
attached properly by trying to lift it
from the chassis.
remove the safe2go car seat
· Press the buttons on both adapters to
unlock the Safe2go car seat.
· Lift the Safe2go car seat straight up
from the chassis.
remove the safe2go adapters
· Slide the unlocking button on the chas-
sis attachment points upwards until
you hear a click. The adapter can now
be taken off the chassis.
Maxi-cosi car seat
· The Maxi-Cosi car seat adapters are suit-
able for use with the following Maxi-Cosi
group 0+ car seats: Maxi-Cosi Pebbles,
Maxi-Cosi Cabriofix, Maxi-Cosi City.
· Always observe the instructions in the
manual of your Maxi-Cosi car seat be-
fore you start using the car seat.
· Make sure that the chassis has fully
been unfolded and the brake blocked
during all actions indicated below.
Place the Maxi-cosi adapters on the
chassis (x3)
· The adapter marked with 'R' is placed on