Troubleshooting - Dometic SabreLink150 Instrucciones De Montaje Y De Uso

Troubleshooting

A
NOTICE!
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach
during cleaning as these can damage the device.
➤ Occasionally clean the device with a soft, damp cloth.
10 Troubleshooting
Fault
The remote control
does not work.
12
Possible cause
The plastic tab that isolates the
battery has not been removed
before first use.
The battery of the remote control
is empty.
The remote receiver is placed
within a metal enclosure or
another closed-off location and
therefore the RF wireless signal is
compromised.
The remote control is not paired
to the remote receiver correctly.
SabreLinkFlex
Solution
Remove the plastic tab.
Replace the battery with a bat-
tery of the same type (see chap-
ter "Changing the battery of the
remote control" on page 11).
Place the remote receiver away
from any metal enclosure or
closed-off locations.
Pair the remote control to the
remote receiver (see chapter
"Before first use" on page 11).
EN