Placing And Leveling - LG WFS2139EKD Manual Del Propieratio

Placing and Leveling

Please ensure that transit restraint has been removed before operating your machine.
1
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right side and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is
suggested.
NOTE
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or "
It must be placed on a firm and level floor to prevent spin failure.
2
Check that the machine is level
Open the lid and look from above to see if it is
same as shown.
3
Leveling the machine
Lift the front of the washing machine and twist
the Adjustable Leg until the surface bubble is
placed in the center.
4
Install Anti-Rat Cover (option)
When you are Installing it, lay the washing machine backwards.
Get rid of the sponge attached on the base.
Below following the picture, Install the Anti-Rat Cover with 8
screws into the holes.
Be careful your feet or hands when you are laying or raising the
washing machine.
Caution
If the power is supplied from a cord extension set or generator, the cord extension set or electrical
portable outlet device should be positioned so that it is not exposed to splashing or ingress of moisture.
28
" error can happen to it.
more than 10 cm
more
than
2 cm
Top view of the machine
Adjustable legs
more than
2 cm
SETTING SCREW
Anti-Rat Cover