Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Note: Recommended oil to use in the future is 10W-30,with
a minimum classification of SF/SG), a dded to the unit until
the oil level registers between high (H) and low (L) on the
dipstick.
Note: Do not overfill. Overfilling with oil may result in
engine smoking, hard starting or spark plug fouling.
Replace and tighten the fill cap/dipstick firmly.
Checkingthe OilBefore EachUse
NOTE: Be sure to check the engine
on a level surface with the
engine stopped.
1.
Remove the oil filler cap/dipstick
and wipe the dipstick
clean.
2.
Insert the cap/dipstick
into the oil filler neck, screw it in.
3.
Remove the oil filler cap/dipstick.
If the level is low, slowly
add oil (10W-30, with a minimum
classification
of SF/SG)
until oil level registers
between
high (H) and low (L).
Note: Do not overfill.
Overfilling
with oil may result in
engine smoking,
hard starting
or spark plug fouling.
4.
Replace and tighten
cap/dipstick
firmly before starting
engine.
6as01ine
Use automotive
gasoline
(unleaded
or low leaded to minimize
combustion
chamber
deposits)
with a minimum
of 87 octane.
Gasoline with
up to 10% ethanol
or 15% MTBE (Methyl Tertiary
Butyl Ether) can be used. Never use an oil/gasoline
mixture
or
dirty gasoline. Avoid getting
dirt, dust, or water in the fuel tank.
DO NOT use E85 gasoline.
Refuel in a well-ventilated
area with the engine stopped.
Do not smoke or allow flames
or sparks in the area where
the engine
is refueled
or where gasoline is stored.
Do not overfill
the fuel tank. After refueling,
make sure the
tank cap is closed properly
and securely.
Be careful not to spill fuel when refueling.
Spilled fuel or
fuel vapor may ignite. If any fuel is spilled, make sure the
area is dry before starting
the engine.
Avoid repeated
or prolonged
contact
with skin or
breathing
of vapor.
1.
2.
WARNING! Useextreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
Clean around fuel fill before removing cap to fuel.
A fuel level indicator is located inside of the fuel tank. Fill
tank until fuel reaches the fuel level indictor. Be careful not
to overfill.
Transmissi0n/Gear Oil
The transmission
was filled with gear oil at the factory.
However,
you should
check the gear oil level at this time to make certain it
is correct,
NOTE: Do not operate the tiller if the gear oil level is low. Doing
so will result in severe damage to the transmission
components.
1.
With the tiller on level ground,
pull the Depth Regulator
Lever back and then all the way up until the lowest notch in
the lever is engaged.
See Fig. 3-5.
F
Depth Regulator Lever
Figure
3-5
2.
Remove the oil fill plug from the transmission
housing
cover and locate the main drive shaft situated
inside the
housing.
See Fig. 3-6.
3.
The gear oil level is correct
if the gear oil is approximately
halfway
up the side of the main drive shaft.
4.
If the oil level is low, refer to the Maintenance
&
Adjustments
Section for instructions
on adding
gear oil.
Figure 3-6
SECTION
3 -- ASSEMBLY& SET-UP
9
Publicidad
