3.
Sharpening the Bit
Before sharpening you should know:
•
Keep the Cam in contact with the Cam Guide as you
sharpen—push the Chuck straight into the Port.
•
Only light pressure is required.
•
You will hear a grinding noise
complete each half-turn and each side of the bit face is
ground.
•
The Chuck will rock as you turn it and the Cam rides
on the Guide.
8
White Triangle
Cam Guide
Sharpening
Port
Set depth of bit and
tighten Chuck.
With the machine turned
off, align the White Triangle
on the Chuck with the Cam
Guide. While keeping the
Chuck against the Cam Guide
on the 350X, insert the
Chuck into the Sharpening
Port. Push the Chuck all the
way into the Port.
Tighten the Chuck Knob
while it's still in the Sharpen-
ing Port.
Remove the Chuck and make
sure it is tight so the bit
won't move when you sharp-
en it.
z
z
z
(z
www.drilldoctor.com
z
z
z
z
z)
as you