Publicidad
Idiomas disponibles
Idiomas disponibles
Assemble Hose To Tank
IMPORTANT: Do not attempt to heat or alter hose,
hose nut, or barb prior to assembly.
1. Align hose barb tabs, push hose barb into tank
until it stops (See Figure A).
2. Slide hose nut into place and turn clockwise to
tighten. (See Figure B).
NOTE: Do not use tools to tighten hose nut.
XB Valve
Assemble Hose, Shut-Off & Nozzle
1. Remove protective cap and attach hose to Shut-Off and tighten securely using a 9/16" Wrench, use a 5/8"
Wrench to hold the Shut-Off handle while tightening the hose. Make sure the screen assembly remains
inside of Shut-Off inlet while fastening hose. (See Figure L)
2. Install selected nozzle into the extension nut and tighten nut securely using a 13/16" wrench. Make sure
that valve seat is oriented correctly. (See Figure M)
3. When placing different nozzles on end of wand, make certain the Soft Seat is always used and the white
gasket is facing correctly. The small end of the seat into the Extension. (See Figure N)
ASSEMBLY INSTRUCTIONS
Figure L
See Filter Detail
Filter Detail
BRASS ADJUSTABLE
FAN NOZZLE USES:
Used on
1. Industrial and Concrete Series (Orange)
(USE WITH XL, XR, XB SHUT-OFFS ONLY)
BRASS FLAT FAN TIP
NOZZLE USES:
Used on
1. Industrial and Concrete Series (Orange)
SPRAY
SPRAY
FLOW
ANGLE:
RATE:
PATTERN:
FAN
.2 GPM
65°
FAN
.2 GPM
80°
80°
FAN
.4 GPM
80°
FAN
.5 GPM
95°
FAN
.5 GPM
110°
FAN
.1 GPM
Figure A
Figure M
See Figure N
White Gasket This Side
Figure N
CERAMIC CONEJET TIP
NOZZLE USES:
Used on
1. Turf and Agriculture Series (Green)
2. Industrial and Concrete Series (Orange)
3. Cleaning and Restore Series (Blue)
4. Pest Control Series (White)
SPRAY
SPRAY
FLOW
RATE:
ANGLE:
PATTERN:
.07 GPM
80°
FAN
80°
FAN
.10 GPM
80°
FAN
.10 GPM
80°
FAN
.13 GPM
80°
.20 GPM
FAN
Figure B
COLOR
#4 GREEN
#6 RED
#10 BLACK
#8 GRAY
#12 BROWN
Page 3
Publicidad
