Overview; Initial Operation - Metabo ASR 35 L AutoClean Manual Original

ENGLISH
ENG
Special safety instructions for
ASR 35 M AutoClean:
Warning sign for machines with dust class M:
During discharge and maintenance operations,
note the following:
Clean the appliance before opening it. Wear a dust
mask. Avoid covering third parties with dust.
Provide local filtered forced ventilation. Then clean
the maintenance area.
Do not operate the appliance without the complete
filtration system. (The system comprises filter
cassettes and PE filter bags).
According to tests carried out as per EN 60335
section 1 and 69, the appliance also meets elec-
trical safety requirements relating to the extraction
of a water-air mixture.
Special safety instructions for ASR
35 L AutoClean:
Warning sign for machines with dust class L:
While the appliance is suitable for extracting
substances that pose a slight threat to health, it is
not appropriate for reducing wood dust in inhaled
air.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory
diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in conjunc-
tion with additives for wood conditioning (chro-
mate, wood preservative).

5 Overview

See page 3 (please unfold).
1 Suction power regulator *
2 Rotary switch On/Off/Automatic/AutoClean
3 Volume flow control display
4 Plug socket for power tool
5 Rotary switch for selecting the extraction
hose diameter *
6 PE filter bag *
7 Fleece filter bag *
8 Paper filter bag *
16
9 Upper part
10 Snap lock
11 Container
12 Cable holder (fold it back and use it to
suspend the mains connection lead)
13 Sealing plug (for ASR 35 M AutoClean only) *
14 Suction opening
15 Locking bar (for opening the hood to change
filter cassettes)
16 Locking knob
17 Motor protection filter
18 Filter cassette (according to IFA C)
* depending on equipment/not included in scope
of delivery

6 Initial Operation

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the rating label, match with your
power supply.
6.1 Secure the sealing plug (for ASR 35 M
AutoClean only)
Fit the chain of the sealing plug (13) to the inner
diameter of the suction opening (14).
6.2 Inserting a Paper Filter Bag or Fleece
Filter Bag
Paper filter bags (8) are not suitable for wet vacu-
uming.
Switch off the appliance, remove the mains plug
and open the snap locks (10). Remove the upper
part of the appliance (9) from the container (11).
paper
(To twist the slide, push it slightly towards the
suction hose, and pull it back after twisting).
Holding the new paper filter bag/fleece filter bag
by the flange, slide the bottom part over the
suction connection, and the top part over the latch
pin. Replace the upper part of the appliance on the
container, close the snap locks.
6.3 Inserting a PE Filter Bag
PE filter bags (6) are suitable for both wet and dry
vacuuming.
On the inside of
the suction
opening, push the
red rotary slide
with its "triangle"
marking upwards.