Installation Method - Be Cool all aboard Manual De Instrucciones

Disassemble the fabric of base ,you will see the
across-belt .as the left 4e pictures shows . Taking out
the across-belt from the T groove through rotate , as
picture 4f shows .
This carseat includes a canopy which can be extended
to keep sunshine out when baby is sleeping (Fig 4g.4h)

INSTALLATION METHOD

5
Rear facing (0-18 kg Child) : Vehicle 3 point belt
Place the car seat rear facing on the vehicle seat,the
seat back of car seat is adjusted to most incline
position.(Position 4)(Fig5a)
Route the vehicle lap belt through below armrest, the
shoulder belt is routed through the upper blue belt
guide, buckle the seat belt.(Fig 5a.5b) aconsejable que
gane un poco de espacio, tirando el asiento delantero
que corresponda lo más adelante posible)
NOTE:
• Group 0+ (0-13kg): use position 4
Buckle the seat belt. Rear view of car seat.(Fig 5b)
The complete status as picture 5c.5d shows.
IM 2086.00 ALL ABOARD bo.indd 39
Please refer to 3a - 3f, laying your baby in carseat
correctly. ( FIG 5d)
NOTE:
• Check the car seat belt for no distortion and then
insert into the car buckle .
WARNING
DO NOT place rear-facing child seat on front seat with
aribag DEATH OR SERIOUS INJURY can occur.
6
Forward facing (9-18kg Child) : ISOFIX+Top
tether;
Open the back cover of the icon. (FIG 6a)
Make sure the top tether lies over the child seat. if
not,take the tip tether from the storage box and lay it
over the child seat (6b)
To adjust the length of Top tether, please press button
"a" in (fig.6c). At the same time, pull ribbon "b" in the(
fig.6c ). Pull another ribbon can shorten the length of
Top tether.
Car seat is adjusted to Position 1. or 2. 3, Have your
EN
39
8/1/19 11:18