Pioneer AVH-X8800BT Manual De Instalación página 10

Installation
Precautions before installation
CAUTION
Never install this product in places where, or in a manner
that:

Could injure the driver or passengers if the vehicle
stops suddenly.
 May interfere with the driver's operation of the vehi-
cle, such as on the floor in front of the driver's seat,
or close to the steering wheel or gearstick.

To ensure proper installation, be sure to use the sup-
plied parts in the manner specified. If any parts are
not supplied with this product, use compatible parts
in the manner specified after you have the parts'
compatibility checked by your dealer. If parts other
than supplied or compatible ones are used, they may
damage internal parts of this product or they may
work loose and the product may become detached.
 Do not install this product where it may
(i) obstruct the driver's vision,
(ii) impair the performance of any of the vehicle's
operating systems or safety features, including
airbags, hazard lamp buttons or
(iii) impair the driver's ability to safely operate the
vehicle.
 Never install this product in front of or next to the
place in the dashboard, door, or pillar from which one
of your vehicle's airbags would deploy. Please refer
to your vehicle's owner's manual for reference to the
deployment area of the frontal airbags.
Before installing
 Consult with your nearest dealer if installation requires
drilling holes or other modifications of the vehicle.

Before making a final installation of this product, temporarily
connect the wiring to confirm that the connections are
correct and the system works properly.
 Do not install this product in a position where the opening
of the LCD panel is obstructed by any obstacles, such as the
gearstick. Before installing this product, be sure to leave
sufficient space so that the LCD panel does not obstruct the
gearstick when it is fully opened. This may cause interfer-
ence with the gearstick, or a malfunction of the mechanism
of this product.
Installation notes
 Do not install this product in places subject to high tempera-
tures or humidity, such as:
10

Places close to a heater, vent or air conditioner.

Places exposed to direct sunlight, such as on top of the
dashboard.
 Places that may be exposed to rain, such as close to the door
or on the vehicle's floor.
 Install this product horizontally on a surface within 0 to
30 degrees tolerance (within 5 degrees to the left or right).
Improper installation of the product with the surface tilted
more than these tolerances increases the potential for errors
in the vehicle's location display, and might otherwise cause
reduced display performance.
30°
 When installing, to ensure proper heat dispersal when using
this product, make sure you leave ample space behind the
rear panel and wrap any loose cables so they are not block-
ing the vents.
Leave ample
5 cm
space
5 cm
Before installing this product
1 Remove the trim ring.
Extend top and bottom of the trim ring outwards to remove the
trim ring.
1
1 Trim ring
2 Insert the supplied extraction keys into both
sides of the unit until they click into place.
3 Pull the unit out of the holder.
1
1 Extraction key
Installation with the holder
1 Install the holder into the dashboard.
2 Secure the mounting sleeve by using a screw-
driver to bend the metal tabs (90°) into place.
1
2
1 Dashboard
2 Holder
3 Install this product into the holder.