Switching On/Off; Call Functions; Adjusting The Volume - Shad BC03 Manual Del Usurario

Switching on/off

Switching on: press and hold the button (1b) for a few
seconds until the speaker provides an acoustic signal
and the LED indicator (1a) begins to flash in Blue.
Switching off: press and hold the control button (1b) for
a few seconds until the speaker provides an acoustic
signal and the LED indicator (1a) begins flashing in red
before the device powers off.

Call functions

When there is an incoming call, the speaker will provide
an acoustic signal.
Answering by pressing the button (1b): press the
control button (1b) only once
Answering through a voice command: answer the call
by speaking any word out loud (e.g. "Answer!")
Ending a call: press the control button (1b) only once or
wait until the other person hangs up
Rejecting an incoming call: press the control button
(1b) twice, as soon as you hear the acoustic signal for
an incoming call
Redialling: press the control button (1b) twice. This
depends on the features and configuration of your
mobile phone.

Adjusting the volume

The SHAD BC03 device is pre-programmed with a
volume level that allows for optimal listening at speeds
of up to 80 km/h (50 mph). To adjust the volume, use
the volume controls on the connected device.
Volume perception may vary depending on the position
and separation of the speakers from your ears, as
well as the type of helmet and motorcycle, external
conditions and other factors.
Playing music from your mobile phone
Once the SHAD BC03 is paired to a mobile phone
capable or transmitting music through Bluetooth
activate music on the phone and it will immediately
be heard through the SHAD BC03 device. Music
and volume can only be controlled from the phone or
device, depending on its features and configuration.
While you listen to music, all call features will remain
active. In case you receive an incoming call, music will
pause and, when the call ends, playback will resume.
Likewise, music will resume after making a call.
Behind the case of the SHAD BC03, you'll find a
switch that allows you to select between Mono or
Stereo audio output. Refer to current legislation in
your country and make the appropriate selection.
SHAD shall not be held responsible for misuse of this
feature.
Intercom pairing with a different SHAD
BC03.
Dual Link: Pairing as an intercom while maintaining
hands-free functionality:
• Complete pairing with the phone as described in the
paragraph above "Pairing to a mobile phone or GPS
navigator".
• Switch off Bluetooth
• Make sure both SHAD BC03 devices are switched off.
• Press and hold the control buttons (1b) of both SHAD
BC03 devices until the LED indicators of both devices
begin flashing in Red and Blue.
• Briefly press the control button of one of the SHAD
BC03 devices. After a few seconds, both devices will
pair and intercom functions will be activated.
• Activate Bluetooth
on your phone model, it will automatically detect the
device paired. Otherwise, you will need to select it
manually.
Single Link: Pairing as an intercom only (without
hands-free features):
• Make sure both SHAD BC03 devices are switched off.
• Press and hold the control buttons (1b) of both SHAD
BC03 devices until the LED indicators of both devices
begin flashing in Red and Blue.
• Briefly press the control button of one of the SHAD
BC03 devices. After a few seconds, both devices will
pair and intercom functions will be activated.
A2DP,
®
Intercom functions:
Activating and deactivating intercom functions
between two SHAD BC03 devices: once both SHAD
BC03 devices have been paired and switched on, press
the control button (1b) for two seconds to activate or
deactivate intercom functionality.
Adjusting the volume for intercom functions: you
can adjust the volume by briefly pressing the control
on both phones.
®
on the phones again. Depending
®
11