Warning! :
Only technically qualified service centres can perform the operations described
below!
Warning! :
Before resetting the safety thermostat, it is always necessary to eliminate the
problem causing its activation!
Problem and possible cause
The content of the vat does not heat up:
−
the safety thermostat has been
activated;
−
the heating elements have a failure;
−
selector/switch failure.
−
This manual contains all the instructions required for a proper and safe use of our appliances.
Keep the manual in a safe place for future consultation!
−
This appliance is for catering use, hence they must be used only by trained kitchen staff.
−
The appliance must always be kept under control during use.
Warning! :
The manufacturer shall not be held responsible for injuries or damage due to the non-
compliance with safety rules or an improper use of the appliance by the operator.
−
Some improper operating conditions may even be caused by an improper use of the appliance, therefore
it is important to train personnel properly.
−
All the installation and maintenance operations must be performed by fitters who are members of
an official register.
−
Respect the periods required for maintenance. With this is mind, customers are recommended to sign a
service agreement.
−
In case of failures concerning the appliance, all outputs (electrical power supply and water) must be cut
off instantly.
−
In case of recurrent failures, contact a service technician.
−
Before cooking with the appliance for the first time, wash the interior of the cooking vat thoroughly.
Warning! :
Fill the cooking vat up to a maximum of 40 mm under the overflow border, according
to the maximum level mark, including the food to be cooked.
Warning! :
Before filling the vat, always check that the drainage tap is closed.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Pentole elettriche PI50-78ET
2.4.1. POSSIBLE FAILURES AND THEIR ELIMINATION
Access to components and operation
Safety thermostat
Remove the lower, right front panel, unloose the screws and
remove the support of the connector-block.
The safety thermostat can be reached once the lid of the
connector-block has been removed.
Heating elements
The heating elements can be reached once the lower front
panel has been removed.
Selector/switch
To reach the selector/switch, remove the upper front panel.
Ignition plug and thermocouple
Remove the lower front panel.
3.1. WARNINGS AND HINTS FOR USER
3.2. INSTRUCTIONS FOR USE
05.10.01
pagina
- IT
27